iAmp 350 (Discontinued)
Type: combo amp
Power rating: 350W@4 Ohms
Drivers: 10″ coaxial-speaker with tweeter
Features: Input impedance 1 Megohm passive/20 kilohms active, parametric EQ: Bass/LowMids/HighMids/Treble controls, deep, contour, bright controls, Presets
Size: 17 3/4″ x 14 3/4″ x 12 1/2″
Weight: 60 lbs.

iAmp Doubler
Type: amp head
Power rating: 550 watts @ 4 ohms 310 watts @ 8 ohms
Size: 2.1″H x 10.5″W x 5.4″D
Weight: 3.00 lbs.
Features: 2 independent channels, 2nd channel has XLR in Channel 1 Mid EQ set at 500Hz for electric bass Channel 2 Mid EQ set at 800Hz for upright/acoustic bass. Input Impedance: 1Meg ohm input impedance on both inputs. Trim controls: Adjust channel level, DI, and high pass filter. Controls: Channel switch, Input gain, 3-Band EQ, Master Volume, Mute switch, Effects loop blend EQ: Low, Mid, and High for each channel Variable high pass filter 22-80Hz, 6db per octave. Channel 2 includes switchable Phantom Power, Variable Phase Control, and switchable Variable Notch Filter, Effects Loop: Parallel effects loop with blend control. Wide range of setups via internal jumpers Outputs: Speakon speaker, tuner, effects send, balanced DI out. Frequency Response: 20Hz to 20kHz +/- 3dB Power

Micro
Type: amp head
Power rating: 550 watts @ 4 ohms 310 watts @ 8 ohms
Size: 2.1″H x 8.5″W x 5.4″D
Weight: 2.25 lbs.
Features: 2 independent channels; Channel 1 Mid EQ set at 500Hz for electric bass, Channel 2 Mid EQ set at 800Hz for upright/acoustic bass; Input Impedance: 1Meg ohm input impedance on both inputs Trim controls: Adjust channel level, DI, and high pass filter; Controls: Channel switch, Input gain, 3-Band EQ, Master Volume, Mute switch, Effects loop blend EQ: Low, Mid, and High for each channel Variable high pass filter 22-80hHz, 6db per octave (allows selection of a frequency below which response is reduced, helps boomy rooms and stages); Effects Loop; Outputs: Speakon speaker, tuner, effects send, balanced DI out; Frequency Response: 20Hz to 20kHz +/- 3dB

www.euphonicaudio.com

NC112P
Type: combo
Power rating: 225W@4 Ohms
Drivers: 12″ Speaker, Tweeter
Features: Frequency Response 42 hz – 15 khz, Compressor w/active LED and on/off switch; Enhance control; Semi-Parametric EQ w/level control, Frequency control, On/Off switch; Bass, Mid and Treble controls
Size: 23.75″W x 16.25″H x 16.25″D
Weight: 46 lbs

NC210P
Type: combo
Power rating: 225W
Drivers: 2 x 10″ speakers and tweeter.
Features: Frequency Response 42 hz – 15 khz, Compressor w/active LED and on/off switch; Enhance control; Semi-Parametric EQ w/level control, Frequency control, On/Off switch; Bass, Mid and Treble controls
Size: 23.75″W x 16.25″H x 16.25″D

www.eden-electronics.com

Drome 1×12″
Type: combo amp
Power Rating: 150 W
Driver: 12″ speaker
Features: Compressor/Limiter, Built-in tube simulator, Stretchable mid-control, Bright-filter
Floating balanced XLR output with built-in speaker simulator.
Serial or parallel stereo effects loop.
Stereo monitor input with Bass Eraser-function (for connecting a CD-player; the “bass eraser” filter removes more or less the bass from the signal, so you can play along any Audio CD.)
Separate stereo headphones driver
9-Volt Phantom Power System (for pedals or active electronics)
Weight: 17 Kg/37 lbs.

Microbass II
Type: preamp/DI-Box
Features: Input Impedance 10 Mohms (Ch A), 1 Mohms (Ch B), Tone Controls Bass, Treble, Bright, Midrange, Edge; Power Supply: DC, Battery, 48V Phantom power, EBS Phantom Power System

www.ebs.bass.se

Solstice
Type: 2-channel Preamp/Blender
Features: 1/4” and XLR inputs on each channel, 1/4” + XLR inputs and +15V Phantom Power on each channel (allows either a microphone or pickup input on either channel), Balanced XLR mic input with true gain control for optimum headroom and lowest noise
Full 3 way level / clip indicator, Phase reverse switch, Channel effects loop with send and return jacks, Mute switch, Tuner output (unaffected by mute switch), Stereo input jack, Frequency Response (+/- 3 dB) 20 Hz – 80 KHz
Size: 8.5″ wide x 6.5″ deep x 2.7″ high
Weight: 2.9 lbs

A very versatile 2-channel preamp for blending up to four pickups or microphones. Offers high impedance imput for piezo transducer buffering and phantom power for condenser microphones.

Equinox
Type: parametric equalizer preamp
Features: 3 Band Parametric Equalizer Preamp with frequency sweep control, bandwidth control, and boost/cut control, Two independent notch filters, 20 dB gain switch, True bypass switching of non-activated functions, Mute switch
Size: 8.5″ wide x 6.5″ deep x 2.7″ high
Weight: 2.9 lbs

www.d-tar.com

Personalized Amplification System / Single or Double bass-package
PS1 Power Stand: 12.7 x 66.0 x 66.0 cm, 16 kg
L1 Cylindrical Radiator loudspeaker: 2 pcs. 109.2 x 8.9 x 10.5 cm; top section 6 kg, bottom section 7 kg
B1 Bass Module: 38.0 x 25.0 x 45.7 cm, 13 kg
R1 Remote Control: 4.0 x 7.1 x 14.1 cm, 0.27 kg

Rather a small and very special PA, than a traditional bass amp. This system consists of four modules: the L1 Cylindrical Radiator Speaker, the PS1 Power Stand (with the amp and controls), a cable remote control, and the B1 Bass Module. The single bass package comes with one B1, the double bass package (which is recommended for acoustic bass) comes with two B1 modules.

www.bose.com

BX1200
Type: combo, dual channel
Power rating: 120W@4 Ohms
Drivers: 12″ (aluminium speaker)
Features: input 68kOhm (active), 1MOhm (passive), 4-band EQ, sub-harmonics processor for ultra low frequencies, shape filter, DI-out, insert loop, tape input (for CD player or drum machine), tape output
Size: 509 mm x 410 mm x 406 mm
Weight: 22 kg

www.behringer.com

Electric Blue 12-150 combo
Type: combo
Power rating: 150W
Drivers: 12″
Features: 5band EQ with bright and deep switches, balanced DI output, FX loop, tuner/line out and octave divider
Size: 510mm x 310mm x 490 mm
Weight: 16,5 kg

www.ashdownmusic.co.uk

Ampeg Porta Bass PBC2112
Type: combo amp (also as amp head PB-250 available)
Power rating: 250W RMS
Drivers: 12″ speaker, 1″ Compression Driver
Features: 4band EQ, Removable Telescoping Dolly Style Handle with Wheels
Size: 20.75″ x 17″ x 13.75″
Weight: 45 lbs

www.ampeg.com

Basscube
Type: combo, three channels
Power rating: 400W@8 Ohm
Drivers: 12″ speaker, tweeter (38Hz–18.5kHz)
Features: Inputs Ch1: line, piezo (10 MegOhms) or mic (48 V phantom powered); Ch2: line, piezo (10 Meg Ohms); Ch3: line, mic (48 V phantom power)
DI out, effects loop, EQ: Ch1/2 bass/mid/treble/colour; Ch3 bass/treble; notch filter, compressor
Size: 400mm x 400 mm x 364 mm
Weight: 25 kg

Bassic Performer
Type: combo, dual channel
Power rating: 200W
Drivers: 4 x 8″ speakers (60Hz–18kHz)
Features: inputs piezo 1 Meg Ohms, microphone 600 Ohms, Ch1: bass/middle/treble, Ch2: bass/middle/treble/colour; limiter, subsonic filter, enhancer
Size: 530 mm x 360 mm x 400 mm
Weight: 23 kg

www.aer-amps.de

Contra
Type: combo, single channel
Power Rating: 400W
Drivers: 10″ downfiring (!) woofer, 5″ midrange drive, 1″ Tweeter (with on/off switch), Three-way sealed speaker System
Features: Molded Polymer Enclosure, Three-Band EQ Preamp Section, Combo Jack Input (Either 1/4 in or XLR), Phantom Power on XLR Input, Input and Master Level Controls, Effects Loop with Return Level Control, Switchable Notch/Low Cut Filter, Balanced Direct Out with Ground Lift, Mute Switch and Pre/Post EQ for Direct Out, Switchable Dual Voltage Operation (115/230V), fitted slip cover with cord storage pocket and shoulder strap
Size: 12″H x 15″W x 13″D
Weight: 20 pounds

Since their launch of the series I in the late 1990ies, these amps became very popular among double bassist. They deliver a powerful, very natural and acoustic sound. The unusual downfiring woofer design produces an omnidirectional output of the the lower frequencies to achieve a natural reproduction of a bass instruments’ sound. The high impedance input is suitable for piezo pickups; external preamps are not needed.
The Contra has one channel, the Coda models offers an additional microphone channel with phantom power. For guitarists, all amps are offered with additional reverb effect.

Coda
Type: combo; same as above, but dual channel (for e. g. microphone; with phantom power)

Clarus
Type: amp head
Size: 10.2×8.2×3.5 inches, Weight: 5 pounds
same as Contra/Coda, but a amp head without speaker enclosure.

Focus
same as Clarus, but 800W

Ten2
2 x 10 Combo, 800W, with removable head

www.acousticimg.com