iAmp 350 (Discontinued)
Type: combo amp
Power rating: 350W@4 Ohms
Drivers: 10″ coaxial-speaker with tweeter
Features: Input impedance 1 Megohm passive/20 kilohms active, parametric EQ: Bass/LowMids/HighMids/Treble controls, deep, contour, bright controls, Presets
Size: 17 3/4″ x 14 3/4″ x 12 1/2″
Weight: 60 lbs.

iAmp Doubler
Type: amp head
Power rating: 550 watts @ 4 ohms 310 watts @ 8 ohms
Size: 2.1″H x 10.5″W x 5.4″D
Weight: 3.00 lbs.
Features: 2 independent channels, 2nd channel has XLR in Channel 1 Mid EQ set at 500Hz for electric bass Channel 2 Mid EQ set at 800Hz for upright/acoustic bass. Input Impedance: 1Meg ohm input impedance on both inputs. Trim controls: Adjust channel level, DI, and high pass filter. Controls: Channel switch, Input gain, 3-Band EQ, Master Volume, Mute switch, Effects loop blend EQ: Low, Mid, and High for each channel Variable high pass filter 22-80Hz, 6db per octave. Channel 2 includes switchable Phantom Power, Variable Phase Control, and switchable Variable Notch Filter, Effects Loop: Parallel effects loop with blend control. Wide range of setups via internal jumpers Outputs: Speakon speaker, tuner, effects send, balanced DI out. Frequency Response: 20Hz to 20kHz +/- 3dB Power

Micro
Type: amp head
Power rating: 550 watts @ 4 ohms 310 watts @ 8 ohms
Size: 2.1″H x 8.5″W x 5.4″D
Weight: 2.25 lbs.
Features: 2 independent channels; Channel 1 Mid EQ set at 500Hz for electric bass, Channel 2 Mid EQ set at 800Hz for upright/acoustic bass; Input Impedance: 1Meg ohm input impedance on both inputs Trim controls: Adjust channel level, DI, and high pass filter; Controls: Channel switch, Input gain, 3-Band EQ, Master Volume, Mute switch, Effects loop blend EQ: Low, Mid, and High for each channel Variable high pass filter 22-80hHz, 6db per octave (allows selection of a frequency below which response is reduced, helps boomy rooms and stages); Effects Loop; Outputs: Speakon speaker, tuner, effects send, balanced DI out; Frequency Response: 20Hz to 20kHz +/- 3dB

www.euphonicaudio.com